Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
Centex Mechanical Inc
|
|
Review by:
Guest
|
|
Review content:
The five stars are for Iban and Jonathan's efforts on a difficult install, which was due to incorrect material furnished them, and a lack of a necessary tool.
They arrived promptly before the appointed time, and the unit arrived later. As they were unpacking the material, they found that the wrong size copper tubing was furnished, which was corrected later.
The initial installation went smoothly, until it was time to bolt the compressor unit to an existing concrete slab. They didn't have a hammer-drill to drill into the slab for the mounting bolts, so I loaned them my light-duty 1/2" hammer-drill, and they got two holes drilled until my drill started smoking and quit, and will have to be replaced. They drilled the final hole with their small drivers and my large 1/2" corded drill. It would have take hours without the sacrifice of my drill. They attempted to bolt down the unit with the furnished bolts only to find that the 1/2" bolts furnished were too large, so they drilled out the flanges on the mounting plate to accept the larger bolts. Only three were used as it would have been impossible to drill the third because of the tubing run. Additionally, the ducting cover for the tubing was too small, and is held in place with cable ties that I furnished. I will box in the exposed tubing on the inside wall myself as the ducting is too small for that also.
In the future I would suggest that each installer have a heavy-duty corded rotary hammer drill in the truck, or be furnished one for this kind of mounting.
The unit runs great and cools quickly.
It's been a pleasure to do business with Centex and all the employees I've met.
Thank You,
Tom Thompson
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|