Tri Point Engineering

First off, unless you jack up your car yourself, pull your engine and thoroughly inspect the ""work"" that has been done (which could even mean pulling your engine apart to see if they even put gaskets in where theyre supposed to go instead of just silicone grease), then you may not know what exactly they've done to your car.\r \r Ive taken my care there numerous times, first to just get some basic aftermarket upgrades and that was fine, because I could actually see the new parts.\r \r But finding out over time that they didnt replace parts that they said they were going to replace was incredulous to me.\r \r My car actually got worse taking my car there, my alarm stopped functioning, the key-hole lights stopped working, recurring problems were never fixed.\r \r I would go after these guys for the work they charged me for and did not do, but I dont have the time or money to do it. I just hope they get what they deserve.\r \r These guys are crooks, I suggest taking your car anywhere else, just do not use Tripoint. \r \r It will be a hard lesson learned, one I learned to the tune of several thousand dollars. Pros: You learn a hard lesson Cons: Total ripoff more

These guys are definitely one of the top three shops for RX-7s in so cal. They know rotories inside & out. Many if not all the mechanics race on a regular basis. Although all this expertise comes at a cost, they are also very expensive. Its worth it though, their work is the best. I wouldnt want any one else to work on my third gen! Pros: quality work Cons: expensive more