Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
Bolger Bros Auto Repair
|
|
Review by:
citysearch c.
|
|
Review content:
Previously, at 149,204 miles I had the mass air flow sensor and evap. flow sensor replaced which the mechanic detected using the ECU. This was reason for the check engine light came on. It seem to fix the problem. After driving the truck for a few weeks, I notice the that the engine ran rough and didn't have power at times. This didn't occur all the time, but I knew something was mechanically wrong. After a few more miles the check engine light came on once again. Return the vehicle to the shop with the mileage of 149,409. The mechanic utilized the ECU device which retrieved the engine was running rich, Catalytic Converter was plugged. Causing the power to be sluggish. Spark Plug #4 had a hair line crack, spark plug wires were arching, due to age, and the Idle Air Control motor was leaking vacuum, This caused the engine not to have consistent idle. So, all these old parts were removed and the new parts were installed. Drove the truck home and notice a remarkable different of power and the idle was smooth like it should be. This solve the difficulty and very please with the work preform.
Thank you Hector, the mechanic, and Bolger Bros.
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|