Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
Moo's Machine Works Inc
|
|
Review by:
citysearch c.
|
|
Review content:
My experience with Moo's is a very negative one. Sent a pair of Weber 44IDF's to be rebushed. Recieved a call saying the carburetors were ready for pickup. My wife was dispatched to\r
pick them up and pay the bill. \r
On arriving back at the shop, I inspected the work that had been done for $544.50.First thing I saw was the mangled screws that held the butterflys in place. Second were missing\r
washers that seal the bearings. third was the incorrect position of the butterflies leaving the progression holes exposed. fourth the bushings installed are so tight that they will need to be broken in by hand. \r
If I, and not my wife had picked the carburetors up, there would have been no payment made, and more than likely some legal problems.\r
I feel that the workmanship was unprofessional and the cost\r
extremely high for the low quality work that was done.
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|