Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
Allen Motorsports
|
|
Review by:
citysearch c.
|
|
Review content:
I went to this shop a few years ago with the intention of building a 340 stroker, unfortunately my goals were were bigger than my budget. Anyways I got about as far as a cleaning, magnufluxing, sonic check of the cylinder walls and ran out of cash. I left the block at Tims shop for at least a year got desperate for cash and figured it was worth a shot to go down there to see if they had it. Luckily they did have it in the shop and after a little bit of a hard time they gave up the block. So even though I wasn't able to build my engine it was still a pretty good experience at allen motorsports both Tim and the kid thats into imports (sorry man I forgot your name a few beer bongs ago) are pretty knowledgeable and the completed short block next to the front desk seemed to be machined pretty well (good cross hatch on the cylinder walls and a credit card straight deck). Good luck to the guys at Allen Motorsports hope this review helps. Oh yeah, whats up with no mahle pistons? Get that taken care of Tim.
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|