Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
Temporary Resources Inc
|
|
Review by:
citysearch c.
|
|
Review content:
i have a lot of experience in assembling in different areas.such as with furniture i worked for link Taylor in the sanding department from 1989 to1994.i ran a sander as well as a polish machine in the sanding department. i made bed posts sanded,polished,assembled furniture. also worked at Duracell ,i welded,assembled,packed and inspected batteries from1994 to 2004. ive worked at diebold i made guts for atm machines and used air tools for instance air power drills and air power screw drivers i would read the blue prints of the atm machine and the parts that go to it then assemble them together on a time limit no less it would usauly take eleven min for each atm machine after putting the processer ,cables and screws in it would be complete i would use my air tools to do just that then go to the next one so as you can see ive had quite a bit of experience with assembly work and im use to long hours hot conditions can read a tape measure and read blue prints so please keep me in mind when you need someone for the job.l
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|